1. First, pair your Peak Pro to the app and update the firmware. Link requires firmware version ‘AW’ or newer to operate.
2. Remove the glass from your Peak Pro and gently press the Peak Pro Link stand into the base. 
3. Remove the chamber from your Peak Pro and attach it to the banger.  
4. Insert connector end of Link into Peak Pro base where 3D Chamber attaches. Turn clockwise until seated securely.
5. Select the silicone joint adapter that fits your glass rig (10mm or 14mm) and place it onto the elbow joint of the banger. You can insert the banger onto the Link stand to keep it upright while the Peak Pro Link is not in use.
6. When your glass rig is ready, place the silicone joint adapter into your glass joint opening. The banger should sit upright. The Peak Pro Link cable should sit or hang loosely. 
   Note: Be careful that your cable doesn’t twist or get caught on anything as you get ready to use. You can also gently wrap the cable around your Peak Pro with enough slack to connect to your rig.
7. Select your desired heat setting on your Peak Pro.
8. Start your heat cycle and use your glass rig to take your hit, using the 3D Chamber + Peak Pro as you would normally to control your sesh.  

Chamber: 

• First, clean the reclaim from the 3DXL Chamber with a cotton swab after each dab. For a deeper clean, use 90%+ isopropyl alcohol and let air-dry completely before heating.

Link:

• Before disassembling or cleaning, be sure the device has completely cooled down. 
• Remove and disassemble the banger elbow and silicone joint. 
• The metal elbow and silicone joints can be cleaned with 90%+ iso, as well as the stand.  
• For a deeper clean, soak the elbow and silicone joints in 90%+ iso for 20-30 min. 
• You can also clean the contact points inside the banger and connector with a cotton swab dipped in iso. Let air-dry completely before heating.  
  
  

Warning: Do NOT soak entire Link in iso.

Yes, Link is compatible with all Peak Pro 3D and 3DXL Chambers.

• Pair your Peak Pro to the app and update the firmware. Link requires firmware version ‘AW’ or newer to operate. 
• If issues continue, try cleaning the connection pins between the base/link and chamber/banger with a cotton swab dipped in iso to wipe away any leaked material that may be interfering with the connection.